 |
Prevention of Dents and Scratches
IK Thermotex is more flexible and resilient than traditional carbon or teflon slabs and will not harden in service (as will asbestos). When correctly used, IK Thermotex can prevent or minimise the occurence of dents and scratches on aluminium extrusions and therefore improve yield ratios and productivity.
|
 |
Elimination of "Black Spot"
IK Thermotex has low thermal conductivity (0.16 W / m°C ) approximately 1 / 1000th that of carbon, because of its felted construction . It therefore does not "chill" the hot aluminium at the area of contact, which is the cause of "Black Spot".
|
 |
Excellent Durability
IK Thermotex has a three dimensionally interlocked fibre construction created by needle felting, consequently, IK Thermotex will not fray or curl as woven fabrics do. Such distorsions frequently result in damage to the extrusions being conveyed. Unlike carbon or teflon, IK Thermotex cannot fracture thus eliminating this cause of frequent replacement or refitting.
|
 |
Non-toxic-Safe
IK Thermotex does not emit any noxious gases or injurious substances during its using.
|
 |
Wide and Varied Applications-Versatile
IK Thermotex in its numerous forms can be used in the aluminium extrusion process from the initial table through to the saw charge and for spacer bars and aging furnace crate lining. It may also be used as a cushion material in aluminium plate rolling.
|
 |
Variety of Forms
IK Thermotex may be fabricated into various forms and shapes such as belts, tubes, bars, plates, diamonds etc.
|
 |
Excellent Heat Resistance
IK Thermotex is made of carbon fibre and aromatic polyamide fibre and tolerates temperatures of 350°C to 550°C(660°F-1020°F) At higher temperatures, IK thermotex is only carbonised; it will not melt and will therefore not adhere to hot aluminium.
|
